Power Supply Removal
1. Turn off and unplug the game.
If your game is NOT an eVo skip to Step 5.
2. Unlock and open the cash tower section.
3. Disconnect the LED power connector behind the CPU section (see Figure 3) and carefully
route the wires back through the access hole below the motherboard (see Figure 1).
4. Close and lock the cash tower section.
5. Unlock and open the CPU section.
6. Unplug the IEC connector from the power supply (see Figure 1).
7. Disconnect the power connector from the hard drive (see Figure 2) and remove the wires from
the cable clamp.
8. Disconnect the touchscreen/fan power connector, then remove the harness from the cable
clamp and disconnect the power connector to the other fan.
9. Remove the 2 screws on the right side of the motherboard (see Figure 1) and carefully pull the
motherboard forward after sliding it out of the clips on the left side of the board.
10. Disconnect the centronics power connector (black, yellow, and red wires--see Figure 4).
11. Disconnect the I/O board power connector (black, yellow, blue, and black wires--see Figure 5)
located at J6 on the I/O board.
12. Disconnect the power supply connector from the motherboard (see Figure 6).
13. Remove the standoff securing the twist clamp in the upper right corner of the game, then undo
and remove the clamp (see Figure 7).
14. Remove the wires (black and yellow) running to the LCD monitor power connector from the
cable clamp, then disconnect the connector (see Figure 4).
15. Remove the 2 screws fastening the power supply and mounting bracket to the game (see
Figure 7).
16. Remove the power supply.
Power Supply Installation
1. Install the new power supply and bracket in the game and fasten them with the 2 screws that
were used to fasten the old power supply and bracket (see Figure 7).
2.
EVO ONLY:
Locate the LED power connector on the new power supply harness and route the
wires down toward the access hole (see step 3 above).
3. Replace the twist clamp around the larger set of wires that will run to the motherboard and I/O
board, then reinstall the standoff (see Figure 7).
4. Reconnect the centronics power and LCD monitor connectors (see Figure 4), then replace the
wires running to the monitor in the cable clamp.
5. Reconnect the I/O board and power supply connectors on the I/O board and motherboard
respectively (see Figures 5 and 6).
Troubleshooting Information - Removal/Installation of Power Supply -
FORCE EVO (all models)/EVO Wallette/Elite Edge
Megatouch FORCE Technical Reference Manual
ATTENTION:
OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DEVICES
Removal/Installation of Major Assemblies -
FORCE EVO (all models)/EVO Wallette/Elite Edge